7 Maintenance Tips for your Refrigerator

7 Maintenance Tips for your Refrigerator

Have been wondering how well you can maintain your refrigerator? Then you are in the right place. Below we are going to discuss seven ways of maintaining your refrigerator so as to ensure they run efficiently.

1. Always check the door rubber seals.

Loose door seals may let cool air from the refrigerator seep out. This, therefore, will cause the refrigerator to work harder than it is required and this may waste a lot of energy. Always ensure that there are no food residues stuck in the seal.

You can clean the seal using toothbrush together with a solution of water and baking soda, it is recommended you do this at least twice a year.

You can also try the dollar bill test. This is where you close the bill in a way that it is half in, half out. If it easily slips out, then your door seals need to be replaced.

2. Ensure the coils are always clean.

Behind the refrigerator are condenser coils. When these coils are covered with dust, they affect the efficiency of the refrigerator. So it is good to at least vacuum them with brush attachment at least twice a year to ensure that your refrigerator works perfectly.

3. Defrost

a) Self-defrosting refrigerator

When frost accumulates to a thickness of one-half inch on the inside wall of the refrigerator, then you don’t need to worry if you got this kind of refrigerator in your house.

This is because this kind of refrigerator will heat up the cooling coil every six to eight hours to melt any frost that has accumulated in the coil.

b) Manual defrost refrigerators

This is quite different from the self defrost type. When the frost has accumulated in here, the fridge cannot automatically melt it down. You will need to remove all the stored food and unplug the unit or turn off the thermostat.

Unplugging will allow the frost to melt. Once the frost completely melts, plug the unit back on and wait until it reaches its operating temperature then you can restock your food back.

4. Setting the temperature right

Always ensure that your refrigerator temperature ranges between 36 to 40 degrees Fahrenheit. The freezer, on the other hand, should always be at 0 degrees.

5. Fill up the refrigerator

For the refrigerator to maintain a low temperature, they will need a “thermal mass” (a lot of stuff inside). This is because cool drinks and foods in the refrigerator will easily absorb the warm air that seeps in when you open the door.

In case you see that your fridge is too big and there are some spaces left, then you can simply store some jugs of water in there to fill up space.

It is also important to note that in case of a power breakout, keep the refrigerator door closed and use the food in the pantry.

This is because a closed refrigerator will ensure the food is safe for about four hours. In addition, the freezer temperature will be maintained for up to 48 hours if your refrigerator is filled up and 24 hours if it is half full.

6. Regular cleaning of the interior

It is advisable to clean your unit once a week. You can use a wet cloth to wipe all around and remove spills and crumb from the shelves. Using an all-purpose cleaner will make your job easier as it takes down sticky sills and stain without much struggle.

This cleaner can also be used on the door and the handle. While wiping the refrigerator, it is recommended that you use the “grain” or follow the pattern that s visible in the stainless steel.

7. Deodorize

It is good to freshen up your refrigerator and remove odors with specifically designed refrigerator deodorizer. This kind of deodorizer is said to be up to 50 times more effective in removing food odors compared to baking soda.


Maintaining your refrigerator will ensure that you get the best service out of it. Never wait until you detect a defect for you to rectify the problem. This may reduce the lifespan of your refrigerator and even increase the maintenance expenses.

Keeping in mind the above information will give you a stress-free life when using your refrigerator.

Author: Richard Forest

A BFA in interior design major Richard developed his interest in home automation issues and interior design. Working initially on print publications and then online during vacations and alongside his study. Online website publication was a short step and initially, Richard worked alongside friends setting up reliable online platforms. Setting up Home Morphing was a logical progression where Richard could control the reliability of the reviews and make sure that his name was linked with a site where he could offer value to visitors. Richard is enjoying post-graduate life and working on his own projects with no deadlines. Having moved into his own home the opportunity to spend time researching home-based products is a gift. Read more about Richard Forest on our About Page.